Home » Raised Floors for Exterior

 

Raised Floors for Exterior

 

 

Raised floors for exterior are designed to lay complete flexible flooring when paving outdoor areas where traditional solutions are normally used. A raised floor permits inspection at any time of the elements underneath the new walking surface such as: the floor tile and membrane, any rainwater drainage pipes, inspection holes and grids.


In addition to the traditionale outdoor flooring system, Granitech presents a new type of pavement known as "System-Exte", code GHO System consisting of use of a porcelain panel with a thickness of 15 mm and possible dimensions of 120x60 - 120x30 - 60x60 cm. The assembly between the substrate and the tile is created by preparing the surface with an appropriate high performance adhesive for outdoor use. The support calibrated on the sides will be scaled on the basis of the gauge of the finishing tiles. This system also involves use of a structure made with fixed or adjustable polypropylene supports


Installing the system calls for no special preparation and once laid, it forms a gap between the finished ground level and the support level, thus creating an effective interruption between the floor slab and the finished ground level: this can eliminate problems of rising damp, frost and water infiltrations.
The solution entails the combination of two simple elements: a support structure and finishing slab.


The former is a structure made up of pre fabricated, load bearing fixed or adjustable supports in polypropylene, giving a finished level ranging from a minimum of a few centimetres to a maximum of 15 cm approximately with a technical hallow area of about 13 cm.
By adjusting the height of the ring nuts or by adding minimum shims you'll obtain perfect levelling of the finished paved surface.

The finishing slab creates the walking surface: it is made out of a single layer of 14 mm thick porcelain tile measuring 40x40 cm.
Textured or flamed finishes are mainly chosen for the slabs used for this type of paving.

Laying of the various components is easy: the whole slabs must have their supports laid out according to the modular grid prepared curing the designing phase, the end slabs are cut so as to seal oil the gaps.
The elements are dry laid.


Download PDF

Download all the datasheets of the flooring systems in PDF format, for printing and viewing them offline:
- Technical data for GHT Outside
- Technical data for GHO System

Welcome to Granitech

Granitech deals with design and installation of ventilated walls and raised floors. Using state-of-the art technologies Granitech develops top quality solutions for important projects in contemporary architecture.

Ventilated Facades

Ventilated walls are multi-layer construction solutions for "dry" cladding of outside walls, improving their aesthetic qualities, degree of protection and insulation.

Read more

Floating Floors

A raised floor is a flooring systems designed to meet the different needs of working areas with high concentration of plant engineering systems.

Read more

Glossary

Definitions of terms and phrases commonly used in ventilated and raised applications.

Read more